Support Center

LRM-AS/LRM-1000 Product Overview

The LRM-AS is the Evolve in-wall dimmer, used for dimming incandescent lighting circuits.  It is a “phase-cut” dimmer.  It is not intended to dim CFL bulbs, or low voltage circuits.  More detail on this:
 
  • The LRM-AS can dim resistive loads, such as incandescent and halogen bulbs
  • The LRM-AS cannot drive inductive loads such as magnetic transformers.
  • The LRM-AS cannot generate digital protocols such as PWM, Dali, DMX512, RS485, or analog protocols such as 0-10v and 4-20mA.

There is a small LED on the device, which illuminates when the circuit is OFF.
 
There is an air-gap on the bottom left hand side of the switch, which opens the circuit when pulled out. 
 
Tap top paddle for ON, and the LRM-AS returns to its last set brightness, which does not necessarily mean full brightness; tap bottom paddle for OFF (0% brightness), push and hold top/bottom to control dimming level.
 
The LRM-AS is rated for 500W, provided both heat sinks are not removed prior to installation.  Removal of each heat sink causes a de-rating of the wattage limit by approximately 100W per side.
 
The LRM-1000 is rated for 1000W, provided both heat sinks are not removed prior to installation.  Removal of each heat sink causes a de-rating of the wattage limit by approximately 100W per side.
3c69ff3e06443603ec0ea37e1dacaab9@evolvesupport.desk-mail.com
https://cdn.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete