Support Center

How to replace/reset LFM-20

Replacing

To replace an LFM-20 into a particular network, you must first ensure the Evolve Device Replacement Tool software is registering as “Ready to Replace Device.”  This can only happen after a room number and specific device type has been selected for replacement.  Please refer to Replacement Tool Overview for further detail on using this software.
 
After powering the device, quickly double tap the middle button.  The device requires that both taps occur within approximately 20 milliseconds of each other.
 
A successful enrollment into an Evolve network will be registered by the replacement tool software, and “Device Replacement Successfully” will appear on the screen.  If after multiple attempts the device has not enrolled within the intended network, cancel the software’s replacement attempt, and try resetting the device.  See Resetting below.

Resetting

To reset a device, you must first ensure the Evolve Device Replacement Tool software is registering as “Ready to Reset Node.”  Select “Reset Node” in the software to initiate this command.  A reset node command is not room or device specific.
 
After powering the device, quickly double tap the middle button.  The device requires that both taps occur within approximately 20 milliseconds of each other.
 
A successful reset of a device will be registered by the replacement tool software, and the “Ready to Reset Node” screen will disappear.
3c69ff3e06443603ec0ea37e1dacaab9@evolvesupport.desk-mail.com
https://cdn.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete