Support Center

Troubleshooting LPM-15

  1. Verify the device is completely plugged into an outlet

  2. Verify the outlet which the device is plugged into, is powered by 120VAC.

  3. Verify the device is plugged into the left, controlled side of the plug-in module.  Remember only the left receptacle is controlled, while the right receptacle is constantly hot.

  4. Verify the device controls the connected circuit using its own local control (tapping the middle button.

    If the circuit does not respond, check the lamping to ensure the bulb is not in need of replacement.

    Verify the sound of the internal relay opening and closing can be heard when turning the device ON and OFF.

    Plug the lamp directly into an available outlet to verify the lamp functions properly

    If the device still does not control the circuit, replace the device

  5. If the device operates the circuit properly but is not being controlled properly by another Evolve device, do NOT replace the hardware. 

    First, verify the device is installed within the correct guest room.  Check the sticker on the device.

    Try “Resending All Data” to the device using the Evolve Device Replacement Tool

    Reset & “Replace Fail” the device into the proper network
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found