Support Center

How to install DS-100-R

  • Main sensor:

    First the main sensor must be activated.  Using a slot-head screwdriver, remove the main sensor’s lid by pressing gently against its exposed connector. 

    Separate the main sensor’s two sections by first removing its lid and then removing its internal components. 

    Remove the clear battery insulator by pulling it away from the main sensor.

    With the main battery insulator removed, reinsert the internal components into the main sensor’s enclosure before reattaching its lid.  Note: ensure the main sensor’s button aligns with the button hole of its lid.  This button may need to be accessed later for programming.

    A hole should be drilled into the doorframe using a 19mm wide drill bit. The hole should be 65mm deep.  After it is inserted into the hole, the main sensor should be secured with its 2 provided set screws.

  • Magnet: should be drilled into the door using a 19mm wide drill bit.  The hole should be 15mm deep.  A small amount of white glue (PVA) should be used inside the hole, prior to inserting the magnet.  Gently tap the magnet in with a rubber hammer.
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found