Support Center

How to install PIR-100

Main sensor:
  1. First the main sensor must be mounted to the ceiling.  To do so, turn the front plastic enclosure/lens counter clockwise to remove it from the main PCB and back plate. 
  2. The PCB and back plate must be installed to the ceiling.  Depending upon the ceiling surface, it may be recommended to use the provided anchors.
  3. Ensure the CR-123 battery is installed.
  4. Gently line up the front enclosure with the PCB and back plate, and turn the front enclosure/lens clockwise for final assembly.
Note that the LED will flash for approximately 2 minutes upon removal or addition of the front enclosure/lens.
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found