Support Center

LCD Configuration

This section covers the many of the built in configurable settings of the Evolve family of LCD’s.  Note: many of these settings can be configured either via RF or manually via on-screen setup.
 
To access the on-screen setup, perform the following steps:
 
  1. Disconnect the 12VDC power to the LCD, by either disconnecting the LCD harness from the LCD circuit board (wall-mounted version) or by unplugging the transformer from the outlet (tabletop version).
     
  2. Reconnect power to the LCD while pushing and holding the top button of the LCD.
     
  3. A menu screen will appear that may be navigated by pressing the associated buttons next to the menu selections.
Screen Brightness, Contrast, Backlight Timer:
 
  • From the Menu selection, push button 1 for Screen settings.
     
  • Tap the associated screen setting button to change the value.
     
  • Note, there are different default values for backlight ON brightness vs. the backlight OFF brightness.  Backlight OFF brightness represents the level following the configured timeout period.
     
  • Press Done when completed.
Button LED Brightness:
 
  • From the Menu selection, push button 2 for LED/LCD settings.
     
  • Tap the associated screen setting button to change the value.
     
  • Note, there are different default values for LED ON brightness vs. the LED OFF brightness.  LED OFF brightness represents the level following the configured timeout period.
     
  • Note: LCD Colors pertains to the RGB version of the LCD ONLY.  Do not adjust this setting for a non-RGB enabled LCD device.  Contact Evolve Technical Support for more detail.
  • Press Done when completed.
3c69ff3e06443603ec0ea37e1dacaab9@evolvesupport.desk-mail.com
https://cdn.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete