Support Center

How to replace/reset LCD device

Replacing

To replace an LCD into a particular network, you must first ensure the Evolve Device Replacement Tool software is registering as “Ready to Replace Device.”  This can only happen after a room number and specific device type has been selected for replacement.  Please refer to Replacement Tool Overview for further detail on using this software.
 
After powering the device, take note of the text that appears along the bottom of the LCD screen.  If the device reads INSTALLED, then the device is already provisioned to an existing network and will need to be reset prior to continuing.  Refer to Resetting.  If the device reads NOT INSTALLED:
 
  1. Disconnect the 12VDC power to the LCD, by either disconnecting the LCD harness from the LCD circuit board (wall-mounted version) or by unplugging the transformer from the outlet (tabletop version).
     
  2. Reconnect power to the LCD while pushing and holding the top button of the LCD.
     
  3. A menu screen will appear that may be navigated by pressing the associated buttons next to the menu selections.
     
  4. Press button 4, which reads Z-Wave.
     
  5. A new screen will appear, select ZW Install
     
  6. Select button 1 Add to Network. 
 
A successful enrollment into an Evolve network will be registered by the replacement tool software, and “Device Replacement Successfully” will appear on the screen.

Resetting

To reset an LCD, it does NOT require the Evolve Device Replacement Tool software to send an associated Reset Node command.  Instead, follow these steps:
 
  1. Disconnect the 12VDC power to the LCD, by either disconnecting the LCD harness from the LCD circuit board (wall-mounted version) or by unplugging the transformer from the outlet (tabletop version).
     
  2. Reconnect power to the LCD while pushing and holding the top button of the LCD. 
     
  3. A menu screen will appear that may be navigated by pressing the associated buttons next to the menu selections. 
     
  4. Press button 4, which reads Z-Wave.
     
  5. A new screen will appear, select ZW Install.
     
  6. Select button 3 Controller Reset.

3c69ff3e06443603ec0ea37e1dacaab9@evolvesupport.desk-mail.com
https://cdn.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete